[ LUGOS ] CDR (ide-scsi) ?!

[Andraz Sraka]

MadDave wrote:

> > Sploh ne. Tekst zgoraj je izpis iz ide-probe.o, ki se starta ob bootanju
> > oz. nalaganju modula za low level IDE. To nima veze s tem, kateri driver
> > (ide-cdrom, ...) je potem nalozen. Gre pa obratno: ce ti ide-probe ne
> > najde neke IDE (ATAPI) naprave, ti potem hig-level driver ne bo delal.
> > Vkljucno z SCSI-over-IDE driverjem.

OK ql ;-] .. samo kaj je pa potem tole ..

ide-scsi: hdc: unsupported command in request queue (0)
end_request: I/O error, dev 16:00 (hdc), sector 0
ide-scsi: hdd: unsupported command in request queue (0)
end_request: I/O error, dev 16:40 (hdd), sector 0
Device not ready.  Make sure there is a disc in the drive.
VFS: Disk change detected on device sd(8,0)
sda : READ CAPACITY failed.
sda : status = 0, message = 00, host = 0, driver = 28
sda : extended sense code = 2
sda : block size assumed to be 512 bytes, disk size 1GB.
 sda:scsidisk I/O error: dev 08:00, sector 0
 unable to read partition table
Sound: DMA (output) timed out - IRQ/DRQ config error?

Lp, Andraz