[ LUGOS ] CDR (ide-scsi) ?!

[MadDave]

Hellow !


To sem ze jaz napisal samo sem bil ocitno ignoriran....
Povem se enkrat...z primeri...

meni ob bootu najde:
hda: FUJITSU MPB3043ATU, ATA DISK drive
hdb: CR-2600TE, ATAPI CDROM drive
hdc: ST3491A, ATA DISK drive
hdd: CRD-8320B, ATAPI CDROM drive

Tu samo testa katere naprave so attachane na masino

Pol pa se nalozi sg.o (al kaj pac ze je):

scsi0 : SCSI host adapter emulation for IDE ATAPI devices
scsi : 1 host.
  Vendor: MITSUMI   Model: CR-2600TE         Rev: 2.30
  Type:   CD-ROM                             ANSI SCSI revision: 02
Detected scsi CD-ROM sr0 at scsi0, channel 0, id 0, lun 0
  Vendor:    LG     Model: CD-ROM CRD-8320B  Rev: 1.24
  Type:   CD-ROM                             ANSI SCSI revision: 02
Detected scsi CD-ROM sr1 at scsi0, channel 0, id 1, lun 0
scsi : detected 2 SCSI cdroms total.
sr0: scsi3-mmc drive: 6x/6x writer xa/form2 cdda tray

smola pa taka....pol mas /dev/scd0 in /dev/scd1, ki jih pol zmountas kak
pac hoces in kam hoces

lp, MadDave=20

On Wed, 3 Nov 1999, Metod Kozelj wrote:

> Howdy!
>=20
> On Wed, 3 Nov 1999, Blaz Podrzaj wrote:
>=20
> > > hda: ST31220A, ATA DISK drive
> > > hdb: WDC AC34300L, ATA DISK drive
> > > hdc: FX120T, ATAPI CDROM drive
> > > hdd: CR-4802TE, ATAPI CDROM drive
> > > Zakaj mi najde CD naprave tudi na hdc in hdd (naceloma naj bi bili sd=
a0
> > > in sda1) ??
> >=20
> > Ker ima=B9 v kernelu podporo za ATAPI CD-ROM, =E8e pa misli=B9 da je ni=
ma=B9, se
>=20
> Sploh ne. Tekst zgoraj je izpis iz ide-probe.o, ki se starta ob bootanju
> oz. nalaganju modula za low level IDE. To nima veze s tem, kateri driver
> (ide-cdrom, ...) je potem nalozen. Gre pa obratno: ce ti ide-probe ne
> najde neke IDE (ATAPI) naprave, ti potem hig-level driver ne bo delal.
> Vkljucno z SCSI-over-IDE driverjem.
>=20
> Peace!
>   Mkx
>=20
> ---- perl -e 'print $i=3Dpack(c5,(41*2),sqrt(7056),(unpack(c,H)-2),oct(11=
5),10);'
>=20
>=20