[ LUGOS ] sambaa

[andy]

interfaces (G) 
     This option allows you to setup multiple network interfaces, so
that Samba can properly handle browsing on all interfaces. 
     The option takes a list of ip/netmask pairs. The netmask may either
be a bitmask, or a bitlength. 
     For example, the following line: 
     interfaces = 192.168.2.10/24 192.168.3.10/24 
     would configure two network interfaces with IP addresses
192.168.2.10 and 192.168.3.10. The netmasks of both interfaces would be
set to
     255.255.255.0. 
     You could produce an equivalent result by using: 
     interfaces = 192.168.2.10/255.255.255.0 192.168.3.10/255.255.255.0 
     if you prefer that format. 
     If this option is not set then Samba will attempt to find a primary
interface, but won't attempt to configure more than one interface. 


Tomaz Izanc wrote:
> 
> evo specialci za sambo
> vprasanje za vas .
> 
> imam sambo instalirano na masini ki ima eth0 in eth1 in v smb.conf
> imam definirana dva porta oz dve mrezne kartice. sedaj pa me zanima
> zakaj se mi dogaja naslednje- ko v winsih nekdo klikne na """>omrezno
> sosescino<"""
> dobi vn vse masine vse "real" wins masine samo linuxa - sambe se pa ne
> vidi. Vidi se sambo samo na ETH0 ????? na eth1 je ni pod >>>omrezno
> sosescino<<< seveda pa
> ce vpisem v winsih pod run \\pa ip od sambe pa zadeva dela .
> se pravi problem je samo v tem da je ne vidim . ce pa vpisem pot potem
> pa pridem na masino.
> je to problem nmbd ja ?
> kako resiti to ?
> 
> --
> ___________________________________________________________
> Tomaz Izanc                      email mailto:tomaz na it-t.si

-- 
---------------------------------------------------------------------------
E-MAIL: andy na x0.org URL: http://andy.x0.org TEL: 301 725 5724 ICQ:
10024539
---------------------------------------------------------------------------