[LUGOS] RTL-8139C+ na Gigabyte NForce2 motherboardih...

[Aleksander Bastl]

David Klasinc wrote:

> -----BEGIN PGP SIGNED MESSAGE-----
> Hash: SHA1
>
> Banzai!
>
> # lspci -v
> 0000:01:0b.0 Ethernet controller: Realtek Semiconductor Co., Ltd.
> RTL-8139/8139C/8139C+ (rev 10)
>         Subsystem: Giga-byte Technology GA-7VM400M Motherboard
>         Flags: bus master, medium devsel, latency 32, IRQ 11
>         I/O ports at c000
>         Memory at ee000000 (32-bit, non-prefetchable) [size=256]
>         Capabilities: [50] Power Management version 2
>
> # dmesg
> NETDEV WATCHDOG: eth0: transmit timed out
> eth0: Transmit timeout, status 0c 0005 c07f media 10.
> eth0: Tx queue start entry 16  dirty entry 12.
> eth0:  Tx descriptor 0 is 0008a06f. (queue head)
> eth0:  Tx descriptor 1 is 0008a04f.
> eth0:  Tx descriptor 2 is 0008a04f.
> eth0:  Tx descriptor 3 is 0008a06f.
> eth0: link up, 100Mbps, full-duplex, lpa 0x45E1
>
> # uname -a
> Linux thefish 2.6.7-gentoo #1 Thu Jun 24 20:22:36 CEST 2004 i686 AMD
> Athlon(tm)  AuthenticAMD GNU/Linux
>
> Ja, tole se dogaja, zakaj tocno nevem, prejsnja 'off-board' mrezna kartica, ki
> je  takisto uporabljala 8139too driver je delovala brez problema.
>
> (forcedeth driver za Nforce2 ne deluje...)
>
> Je imel ze kdo podobne probleme in jih je morda celo resil? Kako drugece kot z
> menjavo strojne opreme?
>
> - --
> David!
> -----BEGIN PGP SIGNATURE-----
> Version: GnuPG v1.2.4 (GNU/Linux)
>
> iD8DBQFA2yi/z0dAgYeWS2wRApTMAKCeiq3UWnubjZQikzF5+OpxWNRLSACffF6C
> dQCnTMVtlhEoMmPA40yB8qo=
> =Rpuc
> -----END PGP SIGNATURE-----

GA-7VM400Mxx   so plosce na osnovi VIA chipseta in delujejo pod linuxom popolnoma
brez problema. RH 9.0 in SUSE 9.1 preverjeno.
Imajo integrirano vse "zivo" na plosci. Mrezni cip je realtek 8100.
Ce zelis uporabiti Nforce driverje potem bos verjetno moral zanejati plosco za
GA-7N400xxx plosco.


Lep pozdrav,
Aleksander