Digitalni fotoaparat

[Matej Zerovnik - LeVaK]

Vceraj sem dobil fotoaparat Minolta DImage 7i. Mal poslikam in grem za PC. 
Prklucm USB, naloadam module... Vse kot po maslu:

Feb 24 13:56:33 etela kernel: usb-storage: *** thread sleeping.
Feb 24 13:56:33 etela kernel:   Vendor: MINOLTA   Model: DIMAGE  CAMERA    
Rev: 1.00
Feb 24 13:56:33 etela kernel:   Type:   Direct-Access                      
ANSI SCSI revision: 02
Feb 24 13:56:33 etela kernel: usb-storage: queuecommand() called
Feb 24 13:56:34 etela kernel: SCSI device sda: 31264 512-byte hdwr sectors (16 
MB)
Feb 24 13:56:34 etela kernel:  sda1

potem mountam z mount /dev/sda1 /mnt/digital in fotoaparat se diskonekta 
sistem pa vrne no partition table found + povno errorjev.

Feb 24 13:57:02 etela kernel: uhci.c: uhci_result_interrupt/bulk() failed with 
status 440000
Feb 24 13:57:02 etela kernel: [cf5a80c0] link (0f5a8092) element (0884a000)
Feb 24 13:57:02 etela kernel:   0: [c884a000] link (0884a030) e0 Stalled 
CRC/Timeo Length=f MaxLen=f DT0 EndPt=3 Dev=3, PID=e1(OUT) (buf=0
Feb 24 13:57:02 etela kernel:   1: [c884a030] link (00000001) e3 SPD IOC 
Active Length=0 MaxLen=e DT1 EndPt=3 Dev=3, PID=e1(OUT) (buf=032f
Feb 24 13:57:02 etela kernel:
Feb 24 13:57:02 etela kernel: usb-storage: Bulk command transfer result=-110
Feb 24 13:57:02 etela kernel: usb-storage: -- transport indicates error, 
resetting
Feb 24 13:57:02 etela kernel: usb-storage: Bulk reset requested
Feb 24 13:57:02 etela kernel: uhci.c: uhci_result_control() failed with status 
440000
Feb 24 13:57:02 etela kernel: [cf5a80f0] link (0f5a8062) element (0884a000)
Feb 24 13:57:02 etela kernel:   0: [c884a000] link (0884a030) e0 Stalled 
CRC/Timeo Length=7 MaxLen=7 DT0 EndPt=0 Dev=3, PID=2d(SETUP) (buf
Feb 24 13:57:02 etela kernel:   1: [c884a030] link (00000001) e3 IOC Active 
Length=0 MaxLen=7ff DT1 EndPt=0 Dev=3, PID=69(IN) (buf=00Feb 24 13:57:02 
etela kernel: usb-storage: -- releasing main URB
Feb 24 13:57:02 etela kernel:

-------------- Tega namece okoli 400 vrstic -------------------

Feb 24 13:57:02 etela kernel: usb.c: USB disconnect on device 3Feb 24 13:57:02 
etela kernel: usb-storage: -- releasing main URB
Feb 24 13:57:02 etela kernel: usb-storage: -- usb_unlink_urb() returned -19
Feb 24 13:57:02 etela kernel: usb.c: kusbd: /sbin/hotplug remove 3

Feb 24 13:57:02 etela kernel: usb-storage: queuecommand() called
Feb 24 13:57:02 etela kernel: usb-storage: *** thread awakened.
Feb 24 13:57:02 etela kernel: usb-storage: Request is for removed device
Feb 24 13:57:02 etela kernel: usb-storage: scsi cmd done, result=0x2
Feb 24 13:57:02 etela kernel: usb-storage: *** thread sleeping.
Feb 24 13:57:02 etela kernel: usb-storage: queuecommand() called
Feb 24 13:57:02 etela kernel: usb-storage: *** thread awakened.
Feb 24 13:57:02 etela kernel: usb-storage: Request is for removed device
Feb 24 13:57:02 etela kernel: usb-storage: scsi cmd done, result=0x2
Feb 24 13:57:02 etela kernel: usb-storage: *** thread sleeping.
Feb 24 13:57:02 etela kernel: usb-storage: queuecommand() called
Feb 24 13:57:02 etela kernel: usb-storage: *** thread awakened.
Feb 24 13:57:02 etela kernel: usb-storage: Request is for removed device
Feb 24 13:57:02 etela kernel: usb-storage: scsi cmd done, result=0x2
Feb 24 13:57:02 etela kernel: usb-storage: *** thread sleeping.
Feb 24 13:57:02 etela kernel: sda : READ CAPACITY failed.
Feb 24 13:57:02 etela kernel: sda : status = 1, message = 00, host = 0, driver 
= 08
Feb 24 13:57:02 etela kernel: Info fld=0xa00 (nonstd), Current sd00:00: sense 
key Not Ready
Feb 24 13:57:02 etela kernel: sda : block size assumed to be 512 bytes, disk 
size 1GB.
Feb 24 13:57:02 etela kernel:  sda: I/O error: dev 08:00, sector 0
Feb 24 13:57:02 etela kernel:  I/O error: dev 08:00, sector 0
Feb 24 13:57:02 etela kernel:  unable to read partition table
Feb 24 13:57:02 etela kernel: uhci.c: root-hub INT complete: port1: 488 port2: 
580 data: 2
Feb 24 13:57:02 etela kernel: hub.c: port 1, portstatus 100, change 2, 12 Mb/s
Feb 24 13:57:02 etela kernel: hub.c: port 1 enable change, status 100
Feb 24 13:57:02 etela kernel: hub.c: port 2, portstatus 300, change 0, 1.5 
Mb/s
Feb 24 13:57:03 etela kernel: usb-storage: usb_stor_exit() called
Feb 24 13:57:03 etela kernel: usb-storage: -- calling usb_deregister()
Feb 24 13:57:03 etela kernel: usb.c: deregistering driver usb-storage
Feb 24 13:57:03 etela kernel: usb-storage: -- calling scsi_unregister_module()
Feb 24 13:57:03 etela kernel: usb-storage: release() called for host 
usb-storage
Feb 24 13:57:03 etela kernel: usb-storage: -- sending US_ACT_EXIT command to 
thread
Feb 24 13:57:03 etela kernel: usb-storage: *** thread awakened.
Feb 24 13:57:03 etela kernel: usb-storage: -- US_ACT_EXIT command received


Se komu kaj sanja? meni se namrec ne vec:) Aja enak problem je na CF in IBM 
microdrive-u.

LeVaK