[LUGOS] External Iomega ZIP drive (USB)

Jerko Bostjan Bostjan.Jerko at skb.si
Wed Nov 21 13:49:47 CET 2001


Kaj ti izpise cat /proc/scsi/scsi ?

-----Original Message-----
From: andrejt at volja.net [mailto:andrejt at volja.net]
Sent: Wednesday, November 21, 2001 1:27 PM
To: lugos-list at lugos.si
Subject: RE: [LUGOS] External Iomega ZIP drive (USB)


Zdravo!

> Ja velja tudi za USB.
> Jaz sem se ukvarjal s podobno zadevo (CF card reader) in SCSI driver je
> obvezen.
> B.

Imam ga vkljucenega v kernel in tudi vse ostale stvari, ki so napisane
na "http://www.caldera.com/SxS/usbzip.htm".


> -----Original Message-----
> From: Metod Kozelj [mailto:metod.kozelj at rzs-hm.si]
> Sent: Wednesday, November 21, 2001 11:30 AM
> To: lugos-list at lugos.si
> Subject: Re: [LUGOS] External Iomega ZIP drive (USB)
>
>
> Howdy!
>
> On Wed, 21 Nov 2001 andrejt at volja.net wrote:
>
>> > Prepricaj se tudi, da imas nalozen modul za zip drive (ce ga nimas
>> > vkljucenega v kernel). Seveda pa to preverjeno deluje za paralelni
>> > zip, vendar mislim, da bi moral delovati tudi z USB-jem
>>
>> Modula nimam nalozenega, ker imam vse vkljuceno v kernel. In ker ob
>> bootu dobim med drugimi tudi to sporocilo -> "Vendor: IOMEGA    Model:
>> ZIP 100           Rev: 48.X", mislim, da mi ZIP drive OK prepozna.
>
> Tale izpis je od USB driverja, ki ti le pove, da je nasel enoto. Da pa
> bo linux znal s to enoto delati, pa rabis se driver za SCSI diske:
>
>  SCSI support -> SCSI disk support

SCSI imam vkljucen v kernel. Sem ze v prvem sporocilu napisal celoten boot
log iz katerega se da to razbrati. Se enkrat ->

<stvari_od_usb_driverja>
...
Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0
Adding Swap: 257032k swap-space (priority -1)
SCSI device sda: 196608 512-byte hdwr sectors (101 MB)
sda: Write Protect is off
 sda: sda4
...

Rabim se kaj? Vkjucil sem vse to kaj je napisano spodaj :

Make certain to either compile in USB support or make it available as
modules. You need at least CONFIG_USB, CONFIG_USB_UHCI, CONFIG_USB_OHCI and
CONFIG_USB_STORAGE. If you have other USB devices you may want to select
more.

These drives also use scsi support so remember to turn this on in the
kernel. Also you will need at least SCSI disk support, and SCSI generic
support. You might need more if you have other devices. I have a CD-R and
also select SCSI CD-ROM support

Za razliko od tega imam jaz vse vkljuceno kar v kernel, torej nimam
nobenega modula.

Se kaksna ideja?

Many thanks in lep pozdrav,

       Andrej.




More information about the lugos-list mailing list