[ LUGOS ] LILO boot

[Rok Pergarec]

Ce z lba34 ne bo delalo je pa se tale fora:

boot = /dev/hda1 <- LI
boot = /dev/hda  <- LILO:

s tem sem mu jest tezave.


On Tue, 17 Apr 2001, Borut Kurnik wrote:

> Lep pozdrav! 
>  
> /usr/share/doc/lilo-21.4.4/README ->
> 
> -------------------------------------------------------------------------
> 
> (<nothing>) No part of LILO has been loaded. LILO either isn't installed
> 
> or the partition on which its boot sector is located isn't active.
> 
>  
> 
> L <error> ... The first stage boot loader has been loaded and started,
> 
> but it can't load the second stage boot loader. The two-digit error
> 
> codes indicate the type of problem. (See also section "Disk error
> 
> codes".) This condition usually indicates a media failure or a geometry
> 
> mismatch (e.g. bad disk parameters, see section "Disk geometry").
> 
>  
> 
> LI The first stage boot loader was able to load the second stage boot
> 
> loader, but has failed to execute it. This can either be caused by a
> 
> geometry mismatch or by moving /boot/boot.b without running the map
> 
> installer.
> 
>  
> 
> LIL The second stage boot loader has been started, but it can't load
> 
> the descriptor table from the map file. This is typically caused by a
> 
> media failure or by a geometry mismatch.
> 
>  
> 
> LIL? The second stage boot loader has been loaded at an incorrect
> 
> address. This is typically caused by a subtle geometry mismatch or by
> 
> moving /boot/boot.b without running the map installer.
> 
>  
> 
> LIL- The descriptor table is corrupt. This can either be caused by a
> 
> geometry mismatch or by moving /boot/map without running the map
> 
> installer.
> 
> LILO All parts of LILO have been successfully loaded.
> 
> ----------------------------------------------------------------------------
> ----------------------------------------------------------------------
> 
> Torej geometrija diska ali boot.b...
> 
>  
> 
> Borut
> 
>  
> 
> -----Original Message-----
> From: |Birkoff| [mailto:damjan.kreft na siol.net]
> Sent: Monday, April 16, 2001 11:53 AM
> To: lugos-list na lugos.si
> Subject: [ LUGOS ] LILO boot
> 
> 
> hi
>  
> imam problem z LILO bootom in sicer ko naložim linux (RH 6.2) in se mašina
> ponovno zažene mi napiše samo "LI" namesto LILO:. Kaj bi lahko bilo narobe?
> imam pa 30GB IBM trdi disk - 4 dos particije in 2 linux (swap in native)
>  
> lp, damjan
> 
>