[ LUGOS ] partition table

[natalia]

Se ze vnaprej oproscam zaradi dolzine maila.
Hotela sem videti kako zgleda Mandrake. Sem instalirala verzijo 7.1 in
se "opekla".
Poskusila sem z expert-mode ker nisem hotela da se mandrake odloci
namesto mene in poglejte mojo novo partition table:

Disk /dev/hda: 64 heads, 32 sectors, 16289 cylinders
Units = cylinders of 2048 * 512 bytes

   Device Boot    Start       End    Blocks   Id  System
/dev/hda1   *         1      3005   3076416    b  Win95 FAT32
Partition 1 does not end on cylinder boundary:
     phys=(1023, 21, 31) should be (1023, 63, 32)
/dev/hda2          3005      6009   3076447+   b  Win95 FAT32
Partition 2 does not end on cylinder boundary:
     phys=(1023, 43, 30) should be (1023, 63, 32)
/dev/hda3          6009      6605    610470    b  Win95 FAT32
Partition 3 does not end on cylinder boundary:
     phys=(1023, 54, 10) should be (1023, 63, 32)
/dev/hda4          6605     16285   9912078    f  Win95 Ext'd (LBA)
Partition 4 does not end on cylinder boundary:
     phys=(1023, 40, 28) should be (1023, 63, 32)
/dev/hda5          6605      6621     16033+  83  Linux
/dev/hda6          6621      7821   1228941   83  Linux
/dev/hda7          7821     11822   4096543+  83  Linux
/dev/hda8         11822     15822   4096543+  83  Linux
/dev/hda9         15822     16285    473886   82  Linux swap

Z cfdisk pride ven se zanimivejsa zadeva.
                              cfdisk 2.10f

                          Disk Drive: /dev/hda
                        Size: 17080616960 bytes
          Heads: 64   Sectors per Track: 32   Cylinders: 16289

   Name       Flags     Part Type FS Type        [Label]       Size (MB)

----------------------------------------------------------------------
                               Unusable                          0.0*
hda1       Boot      Primary  Win95 FAT32                    3150.2*
hda2                     Primary  Win95 FAT32                    3150.2*

hda3                     Primary  Win95 FAT32                     625.1*


                             Logical  Free Space
0.0*
hda5       NC        Logical  Linux ext2                       16.4*
hda6       NC        Logical  Linux ext2                     1258.4*
hda7       NC        Logical  Linux ext2                     4194.9*
hda8       NC        Logical  Linux                          4194.9*
hda9       NC        Logical  Linux swap                      485.3*

                             Logical  Free Space
4.5*

If an asterisks (*) appeears after the size, this means that the
partition is not aligned on cylinder boundaries.

Naj se povem da ne morem vec botat v Win, na sreco pa lahko s flopijem
pridem do RH in seveda Mandrakea ki je res pravi carovnik. Med
instalacijo sem samo dolocila mount point </> za root particijo in
</mnt/win> kot mount za /dev/hda2 kjer imam podatke, nisem spreminjala
velikosti particij. No ugotovila sem da je Mandrake sam dolocil da moram
automaticno mountat tudi hda1 (win) in hda3 kjer imam swap za win. Sicer
pa brez problema mountam vse particije, tudi win.
Poskusila sem ze vse: fdisk /MBR, sys c:, rescue z PartitionMagic ki mi
rece naj unicim in ponovno kreiram particije. Poskusila sem v Linuxu z
gpart in fixdisktable a nic od tega.
Mislila sem da bi popravila samo koncno stevilo cilindrov in na vsaki
particiji zmansala za eno enoto, glede na to kar pravi fdisk
-->Partition 1 does not end on cylinder boundary.
Seveda nimam podatkov o particijah pred katastrofo, no, bom vedela za
drugic. Tako ali tako sem se ze pripravila da ponovno instaliram vse
znova.

Obstaja se kaksna moznost?

Pozdrav,
Natalija