[ LUGOS ] IDE ali disk probem ??

[David Ipavec]

> > VP_IDE: IDE controller on PCI bus 00 dev 39
> > VP_IDE: not 100% native mode: will probe irqs later
> >     ide0: BM-DMA at 0xe000-0xe007, BIOS settings: hda:DMA, hdb:DMA
> >     ide1: BM-DMA at 0xe008-0xe00f, BIOS settings: hdc:DMA, hdd:DMA
> 
> Kaj pa ce bi poskusil z navadnim generic IDE supportom?

Kako se to vklopi ?

> Sicer BM-DMA ne bo delal vendar ze tako zanj pravijo: "your milage may vary".
> Tako bos lahko vsaj videl ce je to morda problem.
> Malce poglej kaj ti izpise "hdparm /dev/hda" in se malce poigraj za
> nastavitvami.

/dev/hda:
 multcount    =  0 (off)
 I/O support  =  0 (default 16-bit)
 unmaskirq    =  0 (off)
 using_dma    =  0 (off)
 keepsettings =  0 (off)
 nowerr       =  0 (off)
 readonly     =  0 (off)
 readahead    =  8 (on)
 geometry     = 525/255/63, sectors = 8448300, start = 0

-- 
 E-mail: David Ipavec <davidi na flux.fe.uni-lj.si>
PGP key: http://flux.fe.uni-lj.si/~davidi/pgpkey
    WWW: http://flux.fe.uni-lj.si/~davidi/