[ LUGOS ] ZIP drive na paralelnem portu

[Andrej Mršek]

Zdravo !

Od kar sem presel na novo jedro 2.2.3 (prej RH5.2 na 2.0.36) mi ne dela
vec ZIP drive na paralelnem portu.
Jedro sem prevajal s podporo za ZIP na paralenem portu. Ko boot-am dobim
naslednja sporocila:
(izsek iz dmes):
...
lp0: using parport0 (polling).
Sound initialization started
<Sound Blaster 16 (4.16)> at 0x220 irq 5 dma 1,5
Sound initialization complete
VP_IDE: IDE controller on PCI bus 00 dev 39
VP_IDE: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0xe000-0xe007, BIOS settings: hda:DMA, hdb:DMA
    ide1: BM-DMA at 0xe008-0xe00f, BIOS settings: hdc:DMA, hdd:DMA
hda: ST34321A, ATA DISK drive
hdc: PHILIPS CDD3610 CD-R/RW, ATAPI CDROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide0: probed IRQ 14 failed, using default.
ide1 at 0x170-0x177,0x376 on irq 15
hda: ST34321A, 4103MB w/128kB Cache, CHS=523/255/63, UDMA
hdc: ATAPI 6X CD-ROM DVD-RAM CD-R/RW drive, 768kB Cache
Uniform CDROM driver Revision: 2.52
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
ppa: Version 2.03 (for Linux 2.2.x)
ppa: Found device at ID 6, Attempting to use EPP 16 bit
ppa: Communication established with ID 6 using EPP 16 bit
scsi0 : SCSI host adapter emulation for IDE ATAPI devices
scsi1 : Iomega VPI0 (ppa) interface
scsi : 2 hosts.
  Vendor: IOMEGA    Model: ZIP 100           Rev: J.03
  Type:   Direct-Access                      ANSI SCSI revision: 02
scsi : detected total.
PPP: version 2.3.3 (demand dialling)
TCP compression code copyright 1989 Regents of the University of
California
PPP line discipline registered.
...
Potem poiskusim z:
mount -t vfat /dev/sda4 /mnt/zip
in dobim naslednje sporocilo:
mount: the kernel does not recognize /dev/sda4 as a block device
       (maybe `insmod driver'?)

Poiskusal sem tudi z ppa kot modulom in potem insmod ppa, dobim
sporocilo o uspesni instalaciji, potem pa
ne morem ZIP-a nikakor pripeti z ukazmo mount. V jedru 2.0.36 je delalo
vse OK.
V howto-jih sem zasledil, da moras (ob boot-u) podporo za tiskalnike na
paralelnem portu nalagati kasneje (kot modul) kot modul ppa. Kako se to
stori ?

LP, Andrej