[LUGOS] 4in1 Card reader, Tronote

[Metod Kozelj]

Howdy!

Eh ... sem s prejšnjim odgovorom malce v temo brcnil.

Kaj pa tole:

MMC support (MMC)

MMC is the "multi-media card" bus protocol.

If you want MMC support, you should say Y here and also
to the specific driver for your MMC interface.

V 2.6.16 je od hardvera podprt samo Winbond W83L51xD SD/MMC Card
interface ... ampak po opisu tvojega TI čipovja bi človek sklepal, da bi
moralo to biti to. Se pravi: potrpljenje do sodnega dne ;)

-- 
Peace!
  Mkx

-- perl -e 'print $i=pack(c5,(41*2),sqrt(7056),(unpack(c,H)-2),oct(115),10);'
-- echo 16i[q]sa[ln0=aln100%Pln100/snlbx]sbA0D4D465452snlb xq | dc


David Klasinc wrote:

>Banzai!
>
> Je ze komu uspelo usposobiti to zadevo pod Linuxom? Baje je ta card reader za 
>memory kartice kar PCMCIA kartica, ki je ze vgrajena v sam notebook. PCMCIA 
>sem usposobil in stvar deluje, tako da mi prepozna kontroler in nalozi 
>driver, vendar potem nikjer ne vidim kake kartice.
>
>tole je lspci:
>
>01:09.0 CardBus bridge: Texas Instruments PCI1620 PC Card Controller (rev 01)
>01:09.1 CardBus bridge: Texas Instruments PCI1620 PC Card Controller (rev 01)
>01:09.2 System peripheral: Texas Instruments PCI1620 Firmware Loading Function 
>(rev 01)
>
>Nekaj sem sicer zasledil, da bi nucal firmware za ta card reader, ki bi ga 
>moral naloziti, tega pa baje ni.
>
>lp,
>  
>
>------------------------------------------------------------------------
>
>_______________________________________________
>lugos-list mailing list
>lugos-list at lugos.si
>http://liste2.lugos.si/cgi-bin/mailman/listinfo/lugos-list
>  
>