RTL-8139C+ na Gigabyte NForce2 motherboardih...

[David Klasinc]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Banzai!

# lspci -v
0000:01:0b.0 Ethernet controller: Realtek Semiconductor Co., Ltd. 
RTL-8139/8139C/8139C+ (rev 10)
        Subsystem: Giga-byte Technology GA-7VM400M Motherboard
        Flags: bus master, medium devsel, latency 32, IRQ 11
        I/O ports at c000
        Memory at ee000000 (32-bit, non-prefetchable) [size=256]
        Capabilities: [50] Power Management version 2

# dmesg
NETDEV WATCHDOG: eth0: transmit timed out
eth0: Transmit timeout, status 0c 0005 c07f media 10.
eth0: Tx queue start entry 16  dirty entry 12.
eth0:  Tx descriptor 0 is 0008a06f. (queue head)
eth0:  Tx descriptor 1 is 0008a04f.
eth0:  Tx descriptor 2 is 0008a04f.
eth0:  Tx descriptor 3 is 0008a06f.
eth0: link up, 100Mbps, full-duplex, lpa 0x45E1

# uname -a
Linux thefish 2.6.7-gentoo #1 Thu Jun 24 20:22:36 CEST 2004 i686 AMD 
Athlon(tm)  AuthenticAMD GNU/Linux

Ja, tole se dogaja, zakaj tocno nevem, prejsnja 'off-board' mrezna kartica, ki 
je  takisto uporabljala 8139too driver je delovala brez problema.

(forcedeth driver za Nforce2 ne deluje...)

Je imel ze kdo podobne probleme in jih je morda celo resil? Kako drugece kot z 
menjavo strojne opreme?

- -- 
David!
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.4 (GNU/Linux)

iD8DBQFA2yi/z0dAgYeWS2wRApTMAKCeiq3UWnubjZQikzF5+OpxWNRLSACffF6C
dQCnTMVtlhEoMmPA40yB8qo=
=Rpuc
-----END PGP SIGNATURE-----