[LUGOS] CD-R pokvarjen?

[Gregor Pirnaver]

Ne vem, če komu to kaj pomaga, ampak meni error javlja pri 
enih Princo CD-jih... ( MITSUMI, CR-4802TE)

On ponedeljek 29 julij 2002 00:13, Martin wrote:
Cdrecord 1.11a15 (i586-mandrake-linux-gnu) Copyright (C) 
1995-2001 Jörg Schilling
TOC Type: 3 = CD-ROM XA mode 2
scsidev: '0,0,0'
scsibus: 0 target: 0 lun: 0
Linux sg driver version: 3.1.22
Using libscg version 'schily-0.5'
atapi: 1
Device type    : Removable CD-ROM
Version        : 0
Response Format: 1
Vendor_info    : 'MITSUMI '
Identifikation : 'CR-4802TE       '
Revision       : '2.1D'
Device seems to be: Philips CDD-522.
Using generic SCSI-3/mmc CD-R driver (mmc_cdr).
Driver flags   : SWABAUDIO
Supported modes: TAO PACKET SAO SAO/R96R RAW/R16 RAW/R96R
Drive buf size : 1638400 = 1600 KB
FIFO size      : 4194304 = 4096 KB
Track 01: data  173 MB
Total size:     199 MB (19:46.16) = 88962 sectors
Lout start:     199 MB (19:48/12) = 88962 sectors
Current Secsize: 2048
ATIP info from disk:
  Indicated writing power: 7
  Is not unrestricted
  Is not erasable
  ATIP start of lead in:  -11597 (97:27/28)
  ATIP start of lead out: 359849 (79:59/74)
Disk type:    Short strategy type (Phthalocyanine or 
similar)
Manuf. index: 20
Manufacturer: Princo Corporation
Blocks total: 359849 Blocks current: 359849 Blocks 
remaining: 270887
Starting to write CD/DVD at speed 4 in write mode for multi 
session.
Last chance to quit, starting real write in 0 seconds. 
Operation starts.
Waiting for reader process to fill input buffer ... input 
buffer ready.
Performing OPC...
cdrecord: Input/output error. send opc: scsi sendcmd: no 
error
CDB:  54 01 00 00 00 00 00 00 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 03 00 00 00 00 06 00 00 00 00 73 03
Sense Key: 0x3 Medium Error, Segment 0
Sense Code: 0x73 Qual 0x03 (power calibration area error) 
Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 22.291s timeout 60s
cdrecord: OPC failed.
cdrecord: fifo had 64 puts and 0 gets.
cdrecord: fifo was 0 times empty and 0 times full, min fill 
was 100%.

LP
-- 
Gregor @ Mandrake 8.2 -> KDE 3.0.1 -> Kmail 1.4 -> ;-)