[ LUGOS ] LILO boot

[Rok Pergarec]

Ce z lba34 ne bo delalo je pa se tale fora:

boot =3D /dev/hda1 <- LI
boot =3D /dev/hda  <- LILO:

s tem sem mu jest tezave.


On Tue, 17 Apr 2001, Borut Kurnik wrote:

> Lep pozdrav!=20
>=20=20
> /usr/share/doc/lilo-21.4.4/README ->
>=20
> -------------------------------------------------------------------------
>=20
> (<nothing>) No part of LILO has been loaded. LILO either isn't installed
>=20
> or the partition on which its boot sector is located isn't active.
>=20
>=20=20
>=20
> L <error> ... The first stage boot loader has been loaded and started,
>=20
> but it can't load the second stage boot loader. The two-digit error
>=20
> codes indicate the type of problem. (See also section "Disk error
>=20
> codes".) This condition usually indicates a media failure or a geometry
>=20
> mismatch (e.g. bad disk parameters, see section "Disk geometry").
>=20
>=20=20
>=20
> LI The first stage boot loader was able to load the second stage boot
>=20
> loader, but has failed to execute it. This can either be caused by a
>=20
> geometry mismatch or by moving /boot/boot.b without running the map
>=20
> installer.
>=20
>=20=20
>=20
> LIL The second stage boot loader has been started, but it can't load
>=20
> the descriptor table from the map file. This is typically caused by a
>=20
> media failure or by a geometry mismatch.
>=20
>=20=20
>=20
> LIL? The second stage boot loader has been loaded at an incorrect
>=20
> address. This is typically caused by a subtle geometry mismatch or by
>=20
> moving /boot/boot.b without running the map installer.
>=20
>=20=20
>=20
> LIL- The descriptor table is corrupt. This can either be caused by a
>=20
> geometry mismatch or by moving /boot/map without running the map
>=20
> installer.
>=20
> LILO All parts of LILO have been successfully loaded.
>=20
> -------------------------------------------------------------------------=
---
> ----------------------------------------------------------------------
>=20
> Torej geometrija diska ali boot.b...
>=20
>=20=20
>=20
> Borut
>=20
>=20=20
>=20
> -----Original Message-----
> From: |Birkoff| [mailto:damjan.kreft at siol.net]
> Sent: Monday, April 16, 2001 11:53 AM
> To: lugos-list at lugos.si
> Subject: [ LUGOS ] LILO boot
>=20
>=20
> hi
>=20=20
> imam problem z LILO bootom in sicer ko nalo=BEim linux (RH 6.2) in se ma=
=B9ina
> ponovno za=BEene mi napi=B9e samo "LI" namesto LILO:. Kaj bi lahko bilo n=
arobe?
> imam pa 30GB IBM trdi disk - 4 dos particije in 2 linux (swap in native)
>=20=20
> lp, damjan
>=20
>=20